How do I know a house is dry enough to close up?
When the readings in the framing, subfloor and room air match the dry reference taken in an undamaged part of the house. Looking dry is not enough, because wood and masonry can hold water well after the surface feels dry.
A dry reference is measured before the drying starts, in a room or wall the water did not reach. That gives the crew a number to aim for in the same house, which is more useful than a general rule about how dry wood should be.
The final readings are kept with the job record. Anyone who opens the wall later can see what the framing read when it was closed, and that record is worth more than a note that says the house was dry.
Why do fans on their own not dry a house?
Fans move air across a surface, which dries the surface quickly, but they do not pull moisture from inside the framing or the cavity. The water stays where it is, and the surface then re-wets from below.
Air needs to pass through the wet material to carry its moisture away. A fan that blows across the top of a soaked subfloor can dry the top layer and leave the rest soaked. The moisture moves up as the surface dries, so the damp returns.
Dehumidifiers are needed to take the moisture out of the air. Without that, the room air fills with water vapor and the materials stop releasing moisture into it. Air movers and dehumidifiers work together, with the placement set by the readings.
Does winter slow structural drying in Gilroy?
It can. Damp outdoor air and closed windows limit the ways moisture can leave the house, so the dehumidification has to do more of the work during the cold months.
A heated house in winter still holds the damp that came in with the water, and it has fewer places to send that moisture. Opening windows to air the house can bring in more humidity than it removes, which is why the crew controls the rooms rather than venting them.
The drying plan changes with the season. A winter loss is logged more often, and the readings are watched for a stall. Gilroy's winter storms, including the atmospheric rivers that reached the valley in January 2023, are a reason to plan the drying around a longer window.
What moves the price of structural drying work up or down?
The number of rooms and the square footage of wet material, the depth of the cavities, whether the crawl space or masonry is involved and how many visits the readings call for. The price is explained and approved before work starts.
A drying job is sized by what is wet, not by the number of rooms in the house. A single wet bedroom with its closet and the wall base is a different scope from a whole ground floor with a crawl space under it, even if the total floor area is similar.
Access and the building itself matter as well. Older masonry and tight framing take longer to dry than open, newer frame, and the crew allows for that when setting the equipment and the visit schedule. The technician explains the scope before the equipment goes in.
Can the same equipment dry a whole house or only the affected rooms?
Usually only the affected rooms, with the adjoining spaces monitored. Sealing the wet area from the rest of the house keeps the humidity where the drying is working.
Running equipment across a whole house spreads the drying load and uses more of the building's capacity than the work needs. The wet rooms are closed off, and the readings in the next room show whether the moisture is moving out of the zone.
If the water reached a shared wall or a ceiling that runs across several rooms, the crew extends the drying to those spaces. The readings decide the boundary, not the layout of the doors.