How long can an appliance leak run before it causes real damage?
Long enough to do serious harm. Even a slow drip can soak the subfloor and the bottom of a cabinet within days, and the damage is hidden until the flooring starts to lift.
A drip of a few drops a minute adds up to a meaningful volume across a week. The water spreads thinly under the flooring and can soak a wide area without making a puddle that anyone would notice. By the time the floor feels different, the subfloor has often been wet for a long time.
This is why a slow leak is treated as seriously as a sudden one. The crew reads the subfloor and the cabinet base before deciding the scope, and the readings show whether the water reached the framing or stayed in the top layer of the floor.
Can I keep the flooring if only the surface got wet?
Sometimes. Sheet vinyl and sealed tile can dry in place when the water stayed on top and did not get under the edge. Water that reached the subfloor usually means lifting the flooring to dry it properly.
Floors that were laid with glue or interlocking joints are harder to dry in place. Water trapped under them holds in the subfloor, so the crew opens a section to reach the wet layer. Where the flooring is in good condition and the subfloor reads dry, the flooring can often be reinstalled.
A cupped or lifted floor that has been soaked for a while is usually replaced. The decision is made from the readings and the condition of the material, and the homeowner is shown the reasons before any flooring is removed.
Why do cabinet bases keep swelling after the leak is over?
Particle board and the paper facing of some panels absorb water and hold it. The moisture stays in the toe kick and the back of the base for a long time, so the swelling continues after the surface is dry.
The toe kick is a hidden space that rarely gets air. Water that runs under a dishwasher can sit there for days, and the material expands slowly as it takes the moisture up. Pulling the toe board and drying the cavity is often the only way to stop the swelling from continuing.
Once a cabinet base has swelled beyond its normal shape, it does not usually return. The cabinet may need replacing, and the crew's job is to dry the structure beneath it so the new or repaired cabinet is set on a dry floor.
What moves the price of appliance leak work up or down?
How long the leak ran, the type of subfloor, whether the cabinets have to come out, and how many rooms the water reached. The price is explained and approved before work starts.
A short leak that was caught quickly usually needs a small floor section opened and a few days of drying. A leak that ran for weeks can mean the cabinets, the flooring and part of the wall all come into the scope, and the work is sized to match.
Access to the appliance is the other factor. A dishwasher built under a counter with no space behind it takes more time than a washer with clear access on the open side. The technician shows you where the work lies before anything is removed.
Should I run the appliance again to check whether it is fixed?
Not until a technician has checked the fitting and the drain. A test run can add water to a floor that is still drying and can hide a second failure.
Once the failed hose, seal or fitting is replaced, the appliance can be tested. The test should be done with the drying equipment in place so any new water is caught early and the readings can show whether the repair held.
If the appliance is a washer, check the drain hose and the standpipe as well as the supply. Many laundry losses are drain overflows rather than supply failures, and a repair to one side alone leaves the other open.