Is creek water treated as clean water?
No. Water that has run across ground, roads and fields before entering a building is handled as contaminated, whatever it looks like. That decision drives which materials come out and how surfaces are cleaned before drying starts.
Supply water from a broken pipe starts clean and only becomes a problem once it has sat. Creek water never starts clean. It has picked up soil, whatever was on the road surface and whatever was on the ground it crossed, and it deposits a share of that inside the building as the level falls.
In practice this means porous material below the water line is removed rather than dried in place. Carpet pad, fiberglass batts and the paper faces of soaked drywall are the usual losses. Structural wood, concrete and the framing itself are normally cleaned and kept, because they can be washed and then dried to a measured target.
How high does the water have to be before the wall is affected?
Lower than most people expect. Drywall draws water upward well past the visible level, and the gap behind the baseboard lets water into the cavity even from an inch of standing water.
A moisture meter usually finds wet material several inches above the tide line, and sometimes much higher where a wall is tight to a slab or holds insulation. That is why a crew maps the wet area before deciding where to cut, instead of working to the line a homeowner can see.
The same reasoning applies to cabinets and built-in furniture. The bottom rail of a run of cabinets will hold water in the kick space long after the floor looks dry, and that is a part of the room nothing can reach without pulling the toe board off.
What decides how much work a flooded Gilroy house needs?
Four things: how deep the water got, how long it stood, how much of the floor plan it reached, and what the wet materials are. The work is explained and approved before anything starts, and nothing is removed without you seeing why first.
Depth and time between them set how much material has to come out. An inch for an hour on a tiled slab may need little more than extraction and a few days of drying. The same inch left overnight in a carpeted room with drywall and batt insulation turns into removal, cleaning and a longer dry.
Access and building type matter as well. A single-story slab house with wide doorways is straightforward to move equipment through. A raised floor, a tight crawl space, several levels or a tenanted unit each add handling, and a commercial space has the extra question of which areas have to stay usable. All of that is set out before the work is agreed.
Does a reservoir release change what happens downstream?
It can be part of a rise. Valley Water has publicly estimated that about half of one Miller Avenue rise came from a release of roughly 1,000 cubic feet per second, with the rest from rainfall runoff.
The district reports that Uvas Reservoir last spilled in February 2019 and says spills are controlled and carry no flood risk. For a homeowner the useful point is not the mechanism but the timing: a creek can keep rising after the rain has stopped, so a building that stayed dry through the storm is not necessarily out of it.
That is one reason crews here do not call a job finished on the day the water leaves. A second rise within the same storm sequence can put water back into a building that has already been pumped, and the drying plan is set with that possibility in mind.
What should I do in the first hour?
Protect people first, then limit the spread. Keep out of standing water that may be near electrical circuits, move what you can lift above the water line, and photograph the room before anything is touched.
Photographs taken before cleanup are worth more than any taken afterward, because they show the depth and the extent while the evidence is still there. Take them from the doorway and from inside each affected room, and include the tide line on the wall where there is one.
After that, do not start pulling up flooring or cutting drywall. A wet floor covering can be the only thing keeping sediment out of the layers below, and an unplanned cut makes the drying harder to control. The first steps after creek water enters a home guide sets out the order in more detail.