A well can take in floodwater, runoff or sewage at the surface, and a house that depends on one needs its water checked before it is drunk again. This guide explains why San Martin's creek setting makes that step more likely, what a test is for and what the house's own repairs look like once the water has gone.
Key takeaways
- Floodwater, runoff and sewage can enter a well at the surface, through a damaged cover or past an aged seal.
- A house on a private well should stop drinking from it until a test from a certified laboratory confirms the water is safe.
- San Martin sits on the Upper Llagas Creek system, which has repeatedly flooded the community and Morgan Hill.
- A January 2017 sewer overflow through San Martin reached Llagas Creek, and the city offered well testing afterward.
- Drying the house and testing the water are separate jobs, and a household needs both.
Why is a well a different kind of water problem?
A well draws from the ground, so floodwater, runoff and surface contamination can reach it in ways a city main does not. The water from the tap is only as clean as the well and its setup.
A city water system has a treatment plant and a network of mains between the source and the tap. A private well is shorter, and it depends on its casing, its cover, its seal and the ground around it. When water stands over the well head, or runs across it, some of that water can get in.
That is why a flood that never reached the house can still affect the water. A well in a low spot, or one with a cracked cover or a seal that has aged, can take in surface water even when the floor of the house stays dry. The contamination is the part you cannot see.
Ask whether the well sits at a low point in the yard and how its cover is sealed. Those two facts say more about the risk than a general description of the valley can.
What happened in San Martin in 2017?
In January 2017 a sewer overflow in the Morgan Hill system released sewage through San Martin into Llagas Creek, and the city offered well testing afterward.
Reporting that cited state water regulators put the volume released at about 204,000 gallons, carried by Llagas Creek. The creek drains the same valley that floods the community, so the event is a fair reminder of what a wet season can carry with it.
The city offered well testing in the aftermath. That is the practical lesson: when sewage or floodwater reaches the ground near a well, testing is the step that answers whether the water is safe. A clear-looking tap does not show that a well is clean.
Nothing here says every well in San Martin was affected in 2017. The record establishes the overflow and the offer of testing, and it does not establish which wells were reached. A household that wants to know its own position should test its own water.
Why does San Martin's creek setting matter for wells?
Upper Llagas Creek has repeatedly flooded San Martin and Morgan Hill, which means surface water can stand over the ground where wells draw from.
The Upper Llagas Creek flood protection project runs from Gilroy through Morgan Hill, including San Martin, and it exists because the valley has flooded often enough to need one. A project under construction is a sign that the risk is real, not a sign that it has been removed.
West Little Llagas Creek overflowed on January 8, 2023, and flash flood warnings were issued for Morgan Hill, Gilroy and San Martin, with no major damage reported. A creek that rises quickly can leave silt and debris on land near a well head in a single storm.
Where the land slopes toward the creek, rain that falls around a well moves toward it. A yard that drains toward the well is one to look at after every storm, and the cover should be checked at the same time.
What does a water test check after a flood?
A test should cover bacteria and the chemicals that a flood or sewage can carry. The laboratory named on the report is the one to trust, not the company that visits the house.
The usual first test looks for bacteria that signal contamination from surface water or sewage. A certified laboratory reports the result, and that report is what a household should keep. A visual check of the water is not a test, however clear the water looks.
Ask whether the test also covers the chemicals a flood or sewage may carry, and ask how the sample is to be collected. A sample taken from a faucet that has not been cleaned can give a misleading result, so follow the laboratory's collection instructions exactly.
Test again if the first result is unclear or if the water changes taste, color or smell. A good result from a day after the event is a useful reading, not a permanent all-clear.
Should the house keep drinking from the well?
No. Until a test confirms the water is safe, use water from a source you know is clean for drinking, cooking and brushing teeth.
Bottled water or water from a known safe supply is the practical answer while a test is pending. Do not treat boiling as a substitute for a test, because boiling does not remove every chemical a flood or sewage can carry.
Showering and washing dishes carry different risks from drinking. Keep children and anyone with a weakened immune system especially careful, and ask the laboratory whether any use is safe while results are pending.
If a result comes back positive, ask the laboratory and a licensed well professional what treatment or repair is needed. Disinfection is a repair decision, and it should be confirmed with a retest once it is done.
What does the house itself need after the water?
The house is dried and checked separately from the well. Materials wet by floodwater come out or are dried to readings, and walls and floors are not signed off until the moisture is gone.
The well and the house are separate problems. Water that reached the living space is handled as floodwater: standing water is removed, materials that cannot be dried in place are taken out and drying runs to readings. The crew documents each visit.
A house on a well often has a pump, a pressure tank and a line into the building, and those can be wet or contaminated too. Ask the crew to check the equipment below the floor or in a utility room, because those items are easy to miss.
Repairs to the well head, the casing and the pump belong to a licensed well professional. The drying crew can say what it has seen, but it does not stand behind the construction of the well.
How do septic and sewage fit into the picture?
Septic systems and sewer backups can add a second source of contamination, and both need checking before a house returns to normal use.
Where a house has a septic system, a flood can saturate the drain field and push water back toward the house. A sewer backup brings its own contamination, and it can travel into the same low rooms as floodwater.
Ask the crew whether the septic or sewer line was checked as part of the job. A backup that is cleaned up but not traced to its cause will return. The page on sewer backup covers the cleanup steps, and a separate check covers the system itself.
Keep a record of every system checked, with the date and the person who checked it. That record helps if the house is sold, if an insurer asks what was done or if a neighbor's well later tests poorly.
When is the water safe again?
When a test from a certified laboratory shows the water is safe after any repair, and the house is dry. Two clean results over time are better than one.
The end point is a laboratory report, not a feeling about the water. After a repair or disinfection the well is retested, and the result is kept with the house records. The crew can help with the drying, but the test has to come from the laboratory.
Keep the water conservative until both the well and the house are finished. Returning to drinking the water early is one of the most common causes of avoidable exposure, and a few days of bottled water is far less trouble than a second round of problems.
Plan a follow-up test for the season after a wet winter. A well that was clean in dry weather can change after a storm, and a second check is the only way to know.
Frequently asked questions
Does a flood always contaminate a well?
No. Whether a well is affected depends on how the water reached it, the condition of the cover and seal and the ground around it. Only a test can say whether a particular well is safe.
Can I use the well for washing the car or watering the garden?
Non-drinking uses carry less risk, but keep standing water and runoff away from the well head while the test is pending, and avoid spraying water toward the house until the results are back.
How soon after a flood should the water be tested?
As soon as practical after the water has receded, and again after any repair. The laboratory can advise on timing for the specific tests it runs.
Will the house insurer cover the testing?
That depends on the policy and the cause of the loss. Ask the insurer in writing, and keep the laboratory report with the claim file.
Does a clear sample mean the well is safe?
Not on its own. Bacteria and many chemicals cannot be seen or smelled, so a clear sample is only a starting point. Wait for the laboratory report before deciding the water is safe.
Who should I call if the test comes back positive?
Start with the laboratory, which can explain the result, then ask a licensed well professional to inspect the cover, the seal and the pump. Keep every report together with the repair records.
Do I need to test if the well stayed dry but the yard flooded?
Yes, it is a sensible step. A yard that held floodwater can put surface water close to the well head even when the well itself stayed dry, and a test is the only way to know.
This guide is general information for Santa Clara County homeowners, not a substitute for an on-site inspection. Prices are estimates. See our disclaimer.